 Find an Applicator
Product Data/MSDS
|
 |
Kemko Grout products feature a wide selection of semi-rigid epoxies and polyureas for filling control joints. These semi-rigid products are designed to: resist difficult environments, absorb heavy wheel loads, protect joint corners, prevent contamination of shrinkage cracks and maintain esthetics. These products may also function as insulators for filling sawcuts after the insertion of wiring for induction loops, traffic signals, and airport runway lighting. Polyurea and epoxy selection factors include the impact loads, temperature ranges, substrate shrinkage, temperature cycling movement, presence of moisture, and sawcut or joint preparation. Viscosities range from self-leveling liquids to non-sag pastes.
Kemko Grouts also include warm and cold weather segmental bonding pastes. Designed for critical load bearing applications, these products feature high heat deflection temperatures (HDTs) and exhibit excellent wet and damp substrate bonds. Capable of supporting sustained loads, including seismic reinforcement and bolt grouting, the 040/041 products are our highest performance pastes.
| Kemko
Grout |
Primary
Uses |
Features |
| 040
Dowel RegSET |
Paste for dowel/rebar/bolt
grouting at moderate to high ambient temperatures. Long work life.
1:1 by volume mix ratio. High HDT and compressive test performance. |
Used in warmer segmental bonding
applications, Injection into wide cracks, Repair of concrete block
walls |
| 041
Dowel QuikSET |
Paste for
dowel/rebar/bolt grouting at low to moderate ambient temperatures.
Short work life, fast curing. 1:1 by volume mix ratio. High HDT
and strengths. |
Used in
cooler segmental bonding applications, Injection into wide cracks,
Repair of concrete block walls |
| 064
Control Joint |
Pourable liquid to fill saw-cut
control joints, wire slots and traffic loops. Excellent durability
for industrial floors. |
Semi-rigid epoxy for control
joints in industrial floors |
| 064
HB Control Joint, HB and 064 Control Joint HBP |
High build
liquid to fill saw-cut control joints, wire slots and traffic loops
on sloped surfaces. Meets FAA P-606 standards for use in airport
high voltage runway lighting slots. |
Thicker
product useful on sloped slabs |
| 189
Polyurea SWL |
High speed pourable or pumpable
polyurea for filling control joints. Cures at low temperatures (to
-25°F) and floor can be re-opened in 2 hours or less. Can also
be used for rapidly closing wall or floor penetrations. |
Workhorse for freezer and
industrial projects. Best when applied by pump but can be hand applied. |
| 132
Polyurea LWL |
Low speed
polyurea for patching and hand mixes. Best for repairs and patches.
Long work life. |
Can be blended
with dried aggregates for mortar/grout mixes. |
| 222
High HDT--Large Void Grout |
Repairing
voids and rock pockets where exotherm of epoxy mass is problematic.
Can be used when high ambient temperature resistance is needed. |
Can be blended
with dried aggregates for mortar/grout mixes. Complies with ASTM
C881, Type IV for structural load bearing |
 Top of page
|
|
